Engee documentation

Voltage-Controlled Voltage Source

A voltage source controlled by voltage.

blockType: AcausalFoundation.Electrical.Sources.VoltageControlledVoltage

voltage controlled voltage source

Path in the library:

/Physical Modeling/Fundamental/Electrical/Sources/Voltage-Controlled Voltage Source

Description

Block Voltage-Controlled Voltage Source It is a linear voltage source controlled by voltage, described by the following equation:

Where:

  • — Output voltage;

  • — gain factor;

  • , — potential values at the control terminals.

To use the unit, connect the + and − ports on the left side of the unit (control ports) to the control voltage source. The two ports on the right side of the unit (output ports) represent the output voltage source. The polarity is indicated by signs + and −.

Ports

The unit has four electrical ports. The + and − connections on the left side of the unit are the control ports, they represent the terminals of the control circuit. The other two ports represent the terminals of the output voltage source. The polarity is indicated by signs + and −.

Parameters

Voltage gain — gain
1 (by default)

The ratio of the output current to the control voltage; dimensionless coefficient.

Initial value of input voltage v1 — initial value of input voltage v1
0 (by default)

The initial value of the input (control) voltage .

Initial value of output voltage v2 — initial value of output voltage v2
0 (by default)

The initial value of the output voltage .

Examples