Engee documentation

RS-MO-4X Setup

Page in progress.

Setting up serial interfaces of the RITMeX RS-MO-4X I/O module.

rs mo 4x setup ru

Description

The block is used to configure serial interfaces of the RITMeX RS-MO-4X I/O module.

Parameters

Port number - port number to configure
1 (By default) | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32

Details

The port numbers are marked on the case of RITM and connecting cables.

  • UART transceiver serial transceiver configuration
    RS-232 (by default) | RS-422 | RS-485-2W | RS-485-4W

Speed - baud rate
9600 (By default) | `19200 | `38400 | `57600 | `115200 | `230400 | `460800 | `912600 | `912600

Data bits - number of transceiver data bits
8 (by default) | 5` | 6` | 7

*Stop bits number of transceiver stop bits
One (by default) | `Two'.

*parity bit transceiver error detection method
No (By default) | Even | Odd | Space | Mark

Details

Explanation of possible meanings:

  • Odd - parity check;

  • Even - odd parity check;

  • Space - parity bit is 0;

  • Mark - parity bit is equal to 1.

Terminating resistor - switching on and off the termination resistor on RS-422/RS-485 lines
None (by default) | 120 ohms

Details
The option is not available with usage of RS-232 interface.

Resistor pull-up - resistor pull-up value
150 kOhm (by default) | `1 kOhm

Details

Setting the resistor pull-up to 1 kOhm is available only for usage of RS-422/RS-485 interfaces and only for RITMeX RS-MO-45 module.