GP-LC-4x SAW
|
Page in progress. |
Sets a periodic sawtooth signal to the GP-LC-4X DAC using the output DMA.
Description
The block is used to specify a periodic sawtooth signal to the GP-LC-4X DAC using the output DMA.
Parameters
| All parameters listed above except the last three set the waveform only at initialisation. If at the first calculation step the corresponding parameters at the block inputs are different, the waveform will be changed. |
Amplitude -
initial amplitude at signal initialisation (data type Float64) in the range from 0 to 5 volts
0.0 (By default).
Frequency -
initial frequency of the signal (data type Float64) in the range from 500 to 13000 hertz
0.0 (By default).
Phase -
initial phase of the signal (data type Float64) in seconds
`0.0 (by default).
Module number — unique module identification
1 (by default) | 2 | 3 | 4 | 5 | 6 | 7 | 8
Details
Used when more than one I/O module of the same type is installed in a real-time machine.
Channel number -
number of the analogue output channel on which this signal will be generated
1 (By default) | 2
Calculation Step -
calculation step in seconds for sending counts to digital output channels from the real-time application
`-1 (By default).