Engee documentation

Resistor (CE)

A resistor model for envelope analysis.

blockType: SubSystem

Path in the library:

/RF/Circuit Envelope/Elements/Resistor (CE)

Description

Block Resistor (CE) simulates a resistor in an envelope simulation environment.

The block implements the ratio:

where

  • — resistance depending on temperature;

  • — the current passing through the capacitor at a certain point in time ;

  • — voltage at the terminals of the capacitor at a certain point in time .

Current and voltage signals in RF blocks consist of common-mode ( ) and quadrature ( ) components at each frequency specified in the block Configuration (CE):

The block icon Resistor (CE) It is dynamic and displays the current state of the applied noise parameter. This table shows how the block icon changes depending on the parameter status. Simulate noise.

The flag Simulate noise installed The flag Simulate noise not installed

resistor

resistor 1

Ports

Conserving

# – — electrical port
electricity

Details

The electrical port corresponding to the negative terminal of the RF circuit.

Program usage name

-

# + — electrical port
electricity

Details

The electrical port corresponding to the positive terminal of the RF circuit.

Program usage name

+

Parameters

Parameters

# Resistance, Ohm — resistance value, ohms

Details

The resistance value in ohms, given as a real scalar.

Default value

50

Program usage name

resist

Tunable

No

Evaluatable

Yes

# Simulate noise — thermal noise simulation

Details

Check this box to simulate thermal noise in the resistor. Then in the block Configuration (CE) also check the box Simulate noise. Both checkboxes are set By default.

This parameter defines a current noise source with a one-sided power density equal to in A2/Hz, where

  • — Boltzmann constant;

  • — parameter value Temperature, K in the block Configuration (CE).

Default value

true (switched on)

Program usage name

simulate_local_noise

Tunable

No

Evaluatable

Yes