Terminator

Output port plug.

terminator

Description

The Terminator block closes output ports that do not connect to other blocks. If you run a simulation with blocks that have unclosed output ports, warning messages will be displayed. Using Terminator blocks to close these ports prevents them from occurring.

Ports

Input

Port_1 - input signal
scalar | vector | matrix | bus

The output port blank of any block. The port accepts signals of all data types.

Data types: Float16, Float32, Float64, Int8, Int16, Int32, Int64, UInt8, UInt16, UInt32, UInt64, Bool.

Support for complex numbers: Yes

Additional options

C code generation: Yes

Examples

Creating Engee Function blocks with state variables
Using buses
Modelling a bipolar NPN transistor
Permanent magnet synchronous motor
Custom block libraries
Calculation of mass flow rate when fluid flows through pipes of different cross-sectional shapes
Value added tax (VAT)
Modelling a mechanical rotational system with a friction element
Identification of model parameters in Engee
Inverting operational amplifier
Crossover in the models
Ratio-to-speed converter using command control in cycles
Multirate filter
Transmitter model
Spectral classifier
Modelling of traffic light control logic
Transformer modelling
Realisation of low-pass and high-pass filters
Step-down transformer
Modelling a bipolar PNP transistor
Generation and analysis of vector signals
LFM signal analysis and processing
Speed control of a simplified synchronous generator
Beamforming based on phase shift
Checking the dynamic behaviour of the thyristor when it is switched on
Voltage fault generation
Code placement in Engee Function blocks
Analysis of transients in linear electric circuits
Callbacks
Modelling the operation of a pneumatic actuator in a wet environment
Discrete FIR filter
Checking the static behaviour of the thyristor when it is switched on
Comparison in models
DC motor with electrical and mechanical parameters
Fault in a network with isolated neutral point
Modelling of an electric oscillating circuit
Simulation of a simplified gearbox
Modelling the motion of an electric vehicle
Polyphase sampling rate converter
Modelling of an inductance coil with hysteresis.
Transmission line model with two-way supply and three-phase fault tripping
Application of programme control of the model
Zero crossing detection
Example
Non-inverting operational amplifier
Mechanical system with rigid progressive motion limiter
Car suspension modelling
Comparative analysis of filters
Mechanical system with progressive friction
Construction of Lissajous curves
Mass-spring-damper model
Mathematical models of bodies
Averaging filter